Ingenico Move 3500 User Manual

Page 23
Move/3500 User Guide
Copyright© 2017 Ingenico
Terminal Configuration
Connect the equipment as described above. The following
screens will be displayed during the configuration of your terminal:
As your terminal
powers up it will go
from a grey screen
to this and
eventually to the
following screen.
Once a connection
has been made
various files will be
downloaded to the
terminal.
Type in your
merchant number
and then press .
Various
file names
will be
displayed
before the terminal
disconnects from
the configuration
host.
The terminal will
attempt to get a
GPRS Signal.
If prompted
confirm
the date by
pressing if it is
correct, or type in
correct date and
then press .
The terminal will
contact the
configuration host.
If prompted
confirm
the time by
pressing if it is
correct, or type in
the
correct time and
then press .

Ingenico Move 3500 Specifications

General

Battery	Li-ion 2200mAh
Security	PCI PTS 5.x certified
Processor	ARM Cortex A5
Connectivity	Wi-Fi, Bluetooth, 3G
Operating System	Telium TETRA
Card Readers	EMV chip, NFC, magnetic stripe
Weight	320g
Display	2.4-inch QVGA (240x320 pixels)