Page 27
Omni Installation Instructions
© Mass Electronics Pty Ltd 2017Chapter 2 – Mechanical Installation
2-3.2 Backup Battery Replacement
The real-time clock battery is user replaceable but it is recommended that it be replaced by qualified Innotech
service technicians.
2-3.2.1 Battery Specifications
•Type: CR-2032 Lithium (user replaceable)
•Nominal voltage: 3 Volts
•Shelf life: 5 Years, dependent on ambient temperature
2-3.2.2 Battery Replacement
1. Open the expansion bay by sliding the cover open.
2. Hold back the retaining clip and remove the battery from the battery holder.
3. Insert a new CR-2032 battery into the battery holder in the correct orientation.
4. Replace the expansion bay cover.
Contains a Lithium Type Battery, Dispose of Properly. (In accordance with local regulations)
Caution: Risk of explosion if battery is replace by an incorrect type.
CAUTION
• The battery should be removed using a non-metallic object. Using a metal object could short the battery if it isn't
completely flat.
• Avoid touching the battery surface with your fingers. The surface can be corroded by the oil on your skin.
IMPORTANT
Figure 2-19: Battery Holder & Battery Orientation
Hold clip back to remove
battery
Remove or Install battery
To Next Page
Loading...
Need help?
General
