Inovance MD500 - Page 159

Appendix C
-
158
-
Function
Code
Name Setting Range Default Change
Group F4: Input Terminals
F4-00 DI1 function selection
0: No function
1: Forward RUN (FWD)
2: Reverse RUN (REV)
(Note: F4-11 must be set when F4-00 is set to 1 or 2.)
3: Three-wire control
4: Forward JOG (FJOG)
5: Reverse JOG (RJOG)
6: Terminal UP
7: Terminal DOWN
8: Coast to stop
9: Fault reset (RESET)
10: RUN pause
11: External fault normally open (NO) input
12: Multi-reference terminal 1
13: Multi-reference terminal 2
14: Multi-reference terminal 3
15: Multi-reference terminal 4
16: Terminal 1 for acceleration/deceleration time selection
17: Terminal 2 for acceleration/deceleration time selection
18: Frequency source switchover
19: UP and DOWN setting clear (terminal, keypad)
20: Running command switchover terminal 1
21: Acceleration/Deceleration prohibited
22: PID pause
23: PLC status reset
24: Swing pause
25: Counter input
26: Counter reset
27: Length count input
28: Length reset
29: Torque control prohibited
30: Pulse input (enabled only for DI5)
31: Reserved
32: Immediate DC injection braking
33: External fault normally closed (NC) input
34: Frequency modication enabled
35: PID action direction reverse
36: External STOP terminal 1
37: Running command switchover terminal 2
38: PID integral disabled
39: Switchover between main frequency source and preset
frequency
40: Switchover between auxiliary frequency source and
preset frequency
41: Motor terminal selection
42: Reserved
43: PID parameter switchover
44: User-dened fault 1
45: User-dened fault 2
46: Speed control/Torque control switchover
47: Emergency stop
48: External STOP terminal 2
49: Deceleration DC injection braking
50: Clear the current running time
51: Two-wire/Three-wire mode switchover
52: Reverse frequency forbidden
53-59: Reserved
1
★
F4-01 DI2 function selection 4
★
F4-02 DI3 function selection 9
★
F4-03 DI4 function selection 12
★
F4-04 DI5 function selection 13
★
F4-05 DI6 function selection 0
★
F4-06 DI7 function selection 0
★
F4-07 DI8 function selection 0
★
F4-08 DI9 function selection 0
★
F4-09 DI10 function selection 0
★