Safety Information
-
4
-
During Storage and Transportation
◆
Store and transport the product according to its storage and transportation conditions. The storage tem-
perature and humidity shall meet relevant requirements.
◆
Do not store or transport the product in places with direct sunlight, strong electric eld, strong magnetic
eld or strong vibration or places that are wet by rain or splashing water.
◆
Do not store the product for over three months. Take stricter prevention measures and perform neces-
sary inspection when the storage time is too long.
◆
Well pack the product before transportation. The product must be placed in a sealed box for long-dis-
tance transportation.
◆
Do not transport the product together with any equipment or articles that may affect or impair the prod-
uct.
Warning
◆
Be sure to use professional loading and unloading equipment to move large or heavy equipment and
products!
◆
When moving the product by hand, grab the product case tightly to avoid dropping the product parts,
causing injury!
◆
Be sure to move the product lightly, pay attention to your step to prevent trip or fall; otherwise, there is
the risk of injury or damage to the product!
◆
When the equipment is lifted by a lifting gear, do not stand or stay in the area below the lifting area.
During Installation
Warning
◆
Before installation, carefully read the product manual and safety precautions!
◆
Do not modify the product!
◆
Do not unscrew the xing bolts and bolts with red mark of the product parts and components!
◆
Do not install this product in a place with strong electric eld or strong electromagnetic interference!
◆
When the product is installed in a cabinet or terminal equipment, the cabinet or terminal equipment shall
be provided with the corresponding protective devices such as reproof enclosure, electrical enclosure
and mechanical enclosure. The protection grade shall comply with relevant IEC standards and local laws
and regulations.
◆
Non-professionals are strictly prohibited from product installation, wiring, maintenance, inspection or
parts replacement!
◆
These operations can only be done by professionals trained on electrical equipment and having knowl-
edge of electrical equipment.
◆
Installers must be familiar with product installation requirements and related technical data.
◆
When you need to install equipment, such as transformers, having strong electromagnetic interference,
install the shield protection device to prevent the product from malfunction!
To Next Page
Loading...
