Inovance MD500

Safety Information
-
5
-
During Wiring
Danger
◆
Non-professionals are strictly prohibited from equipment installation, wiring, maintenance, inspection or
parts replacement!
◆
Do not perform wiring when the power is turned on. Failure to comply may result in electric shock.
◆
Before wiring, cut off the power of all equipment. There is residual voltage in internal capacitor of the
equipment after the power is cut off. Wait for at least 10 minutes before wiring and other operations.
◆
Be sure the equipment and product are properly grounded. Failure to comply may result in electric
shock.
◆
Follow the ESD precautions and wear EDS wrist strap to avoid damage to the equipment or circuit inside
the product.
Warning
◆
It is prohibited to connect the input power to the output terminal of the equipment or product; otherwise,
the equipment may be damaged or re may occur.
◆
When connecting a driving equipment to the motor, be sure that the phase sequence of the driver and
the motor terminal are consistent, so as to avoid reverse rotation of the motor.
◆
The cables used for wiring must meet relevant diameter and shielding requirements, and the shielding
layer of the shielding cables must be reliably grounded at single terminal!
◆
After wiring is nished, be sure there is no screw or bar cables inside the equipment and product.
During Power-on
Danger
◆
Before power-on, be sure the equipment and product are installed properly, the wiring is rm and the
motor unit is allowed to restart.
◆
Before power-on, be sure the power supply meets the equipment requirements to avoid damage to the
equipment or causing re!
◆
During power-on, mechanical devices of the equipment or product may suddenly move. Stay away from
the mechanical devices.
◆
After power-on, do not open the equipment cabinet door or product protection cover; otherwise, there is
the danger of electric shock!
◆
It is prohibited to touch any terminal of the equipment when power is on; otherwise, there is the danger
of electric shock!
◆
It is prohibited to dismantle any device or parts of the equipment and product when the power is on; oth-
erwise, there is the danger of electric shock!