Intel Altera MAX 10 FPGA - Installing the Development Kit

2.3.2. Installing the Development Kit
1. Download the MAX 10 FPGA Development Kit installer package from the MAX 10
FPGA Development Kit webpage on the Intel website.
2. Unzip the MAX 10 FPGA Development Kit installer package. The package creates
the directory structure shown in the figure below.
Figure 4. MAX 10 FPGA Development Kit Directory Structure
documents
board_design_files
examples
factory_recovery
demos
<package rootdir>
3. For the latest issues and release notes, Altera recommends that you review the
readme.txt located in the root directory of the kit installation.
Table 2. Installed Directory Contents
Directory Name Description of Contents
board_design_files
Contains schematic, layout, assembly, and Bill of Material (BOM) board design
files. Use these files as a starting point for a new prototype board design.
demos
Contains demonstration applications when available.
documents
Contains the development kit documentation.
examples
Contains the sample design files for the MAX 10 FPGA Development Kit:
• Board Test System: BTS GUI, Power GUI, and Clock GUI
• Golden Top project for pinout assignments management
• Design Examples: Memory, XCVR, GPIO, ADC, and HDMI
factory_recovery
Contains the original data programmed onto the board before shipment. Use this
data to restore the board with its original factory contents.
2. Getting Started
683460 | 2024.11.20
Send Feedback
MAX
®
10 FPGA Development Kit User Guide
9