Need help?Do you have a question about the Intergraph StudioZ RAX and is the answer not in the manual?
General| Form Factor | Tower |
|---|---|
| GPU | NVIDIA Quadro |
| Operating System | Windows 10 Pro |
| Expansion Slots | Multiple PCIe slots |
| Networking | Gigabit Ethernet |
Document is restricted for use by qualified personnel. Heed warnings and cautions.
Defines document conventions such as bold, italic, monospace, and key combinations.
Details on system setup, OS configuration, and system introduction.
Safety guidelines for the base unit and rack, including grounding and lifting.
Specifications and warnings for installing equipment in the Intergraph rack.
Specifications and guidelines for the domestic AC distribution box and its receptacles.
Specifications and guidelines for the non-domestic AC distribution box and its receptacles.
Instructions for installing the Uninterruptible Power Supply (UPS) into the rack.
Instructions for unpacking and installing the InterRAID-8 disk array cabinet.
Instructions for unpacking and installing the InterServe base unit into the rack.
Instructions for installing the rack-mount keyboard, mouse, and monitor.
Instructions for installing the boot drives into the system's internal RAID slots.
Instructions for connecting system cables and using cable handlers.
Guidelines for installing additional rack-mount equipment.
Instructions for unpacking and installing the InterRAID-8 disk array cabinet.
Instructions for installing the StudioZ RAX base unit into the rack.
Instructions for installing standard RAID disk drives into the base unit.
Instructions for connecting PC Extender cables and using cable handlers.
Guidelines for installing additional rack-mount equipment.
Technical information on standard hardware components like processor and I/O boards.
Description of memory organization, banks, interleaves, and rows.
Lists memory address map assignments for system resources.
Diagram showing the layout of components on the processor board.
Diagram illustrating the functional connections of the I/O expansion board.
Lists reserved I/O addresses used by system devices.
Description of Direct Memory Address (DMA) channels and their assignments.
Diagram showing the layout of connectors and slots on the I/O expansion board.
Diagram showing the layout of connectors on the I/O connector board.
Diagram showing the board layout for Side 1 of the power distribution board.
Diagram showing the assembly layout of the internal RAID section.
Details on 8X and 12X speed CD-ROM drives, including connectors and pinouts.
Information on the 2 GB fixed disk drive, including jumper connectors and SCSI ID selection.
Details on the combo drive, including cable connectors and pinouts.
Restrictions for upgrading and servicing the system, emphasizing qualified personnel.
Procedure for safely opening the system base unit for servicing.
Precautions to protect components from static electricity damage.
Procedure for correctly closing the system base unit after servicing.
Restrictions for upgrading and servicing the system, emphasizing qualified personnel.
Information on available memory kits and upgrade procedures for InterServe/StudioZ.
Information on installing and configuring PCI, ISA, and PnP option boards.
Instructions for connecting external SCSI devices to the base unit's SCSI port.
Guidelines for SCSI cabling lengths and device limitations.
Procedure to disable sync negotiation for specific data transfer rates.
Physical dimensions and weight of the base unit.
Required clearance for front and back of the unit.
Electrical specifications for domestic and non-domestic AC power.
System power consumption, operating temperature, humidity, and heat dissipation.
Procedure for installing/replacing BIOS flash code on the RAID controller.
Procedure for installing/replacing firmware on the internal RAID section.
Steps to set the default RAID configuration for InterServe and StudioZ RAX.
To Next Page