Chapter 4: Operating instructions
26 TruVision DVR 12HD User Manual
In Menu mode: Use left or right arrow buttons to select and up or down
arrow buttons to edit entry.
In PTZ mode: Use to control PTZ.
Playback mode: Use to control playback speed.
Use to control zoom of camera lens.
Enter preprogrammed three
-digit code to call up a preset.
Enter preprogrammed three
-digit code to call up shadow tour.
Use to control focus of camera lens.
Use to control playback (Rewind, Pause, Play, and Fast Forward).
Replay the selected file from the beginning.
Eject the CD or DVD disk.
Press once to enter quick archive mode. Press twice
to start archiving.
Aim the remote control at the IR receiver located at the front of the unit to test
operation.
To change the address of the remote control to the recorder:
1. Press the Menu button on the front panel or right-click the mouse and select the
Menu button. The default display menu window appears.
2. Click Device Management > General Settings.
3. Check the remote control ID value. The default value is 255. This device address is
valid for all IR controls.
Note: The recorder will respond to any remote control that has an address between
1 and 255.
4. On the remote control press the Device button.
5. Enter the device address value. It must be the same as that on the recorder.
6. Press the OK button on the remote control.
To place batteries into the IR remote control:
1. Remove the battery cover.
2. Insert the batteries. Make sure that the positive (+) and negative (−) poles are
correctly placed.
3. Replace the battery cover.
To Next Page
Loading...
Need help?
General
