Interlogix TruVision - General Recorder Settings

Chapter 14: Device management
98 TruVision DVR 12HD User Manual
General recorder settings
Use the General Settings menu of Device Management to configure general recorder
options.
See Figure 27 and Table 14 on page 98 for the general options available. The changes
are immediately implemented once Apply is clicked to save the settings.
Figure 27: General settings of the recorder
Table 15: Description of the Monitor setup window: General settings
Option Description
1.
Language
Define the language of the system.
Select the desired language from the drop-down list and click Apply. The
language displayed changes immediately.
Default is English.
2.
Device Name
Define the recorder name. The default name is TVR 12HD.
Click the edit box and enter the new name from the soft keyboard.
3.
Remote Control ID
The device number to use for the recorder when linking the device to a
remote control. The default value is 255.
4.
Keypad Zone ID
Each recorder in a daisy chain must have a unique zone ID so that it can
be controlled by a RS-485 wired keypad. This is not required when using
IP keypads.
The default value is 1.
5.
Password R
equired Define whether a login password is required to open the menu.
Check the box to enable/disable and click Apply.
Default is Disable.
6.
Enable Wizard
Immediately start Wizard without rebooting the system.
Check the box to enable/disable and click Apply.
Default is Enable.