Chapter 11: Network settings
TruVision DVR 12HD User Manual 77
2. Enter the required settings:
Option Description
1.
Network interface card (NIC) is a device used to connect the recorder
network. Select the NIC type used from the drop-down list.
Default value is 10/100M self-adaptive for the 4 channel recorder and
10/100/1000M self-adaptive for the 8 or 16 channel recorders.
2.
DHCP (Dynamic Host Configuration Protocol) is a protocol for assigning
an IP address dynamically to a device each time it connects to a network.
Check this box if you have a DHCP server running and want your recorder
to automatically obtain an IP address and other network settings from that
server. The DHCP server is typically available in your router.
Default value is Disable.
3.
Enter the IP address for the recorder.
Default value is 192.168.1.82.
4.
Enter the subnet mask for your network so the recorder
within the network.
Default value is 255.255.255.0.
5.
ateway
Enter the IP address of your network gateway so the recorder will be
recognized within the network. This is typically the IP address of your
router. Consult your router user manual or contact your ISP to get the
required information on your gateway.
Default value is 192.168.1.1.
6.
Enter the IPv6 address for the recorder. This is the IP address of the local
network to which the recorder is connected.
Default value is fe80::240:3dff:fe7e:926f/64
7.
When the recorder is connected to an external network (such as the
internet), the second IPv6 address is automatically assigned.
To Next Page
Loading...
Need help?
General
