Intermec EasyCoder 201 II - Media Size; Service; Technical Manual

41
Intermec EasyCoder 201 II – Technical Manual
SETTING UP EASYCODER 201 IIE & 201 IISA, cont'd.
The Service part of the Setup Mode is protected by a password to
avoid unauthorized access. To enter Service, press < Enter >. A
menu asking for a password is displayed:
SETUP:
PASSWD:
Using the numeric keys, type the password 1138 and press < En-
ter >. When typing the password, the digits will be indicated by
stars (****) in the display as they are entered.
Action EasyCoder 201 IIE EasyCoder 201 IISA
Enter Service < Enter ><Enter >
Enter password 1138 + < Enter > 1138 + < Enter >
Return to “Contrast” menu < F5 >< ⇒ >
Exit Setup Mode < Setup >< Save >
Three menus will successively be displayed. In each menu, the
current setup value is displayed within brackets, e.g.:
XSTART:
[0]:
Action EasyCoder 201 IIE EasyCoder 201 IISA
Enter new value Numeric keys Numeric keys
Acknowledge and proceed < Enter ><Enter >
WIDTH:
[640]:
Action EasyCoder 201 IIE EasyCoder 201 IISA
Enter new value Numeric keys Numeric keys
Acknowledge and proceed < Enter ><Enter >
LENGTH:
[1200]:
Action EasyCoder 201 IIE EasyCoder 201 IISA
Enter new value Numeric keys Numeric keys
Acknowledge and proceed < Enter ><Enter >
Service
Media Size
• X-start
• Width
• Length