Intermec PC43d User Manual

Appendix B — Default Settings
142 PC23 and PC43 Desktop Printer User Manual
Error, Information, and Warning Alert Settings
This section describes error, information, and warning alerts and
settings.
To view these settings, from the printer web page, click the Configure
tab, Alerts > Error, Warning, or Information.
Alert settings apply to each of the error, information, or warning alerts
and are configured individually by alert.
Note: These alert settings cannot be configured from the printer Main
Menu.
Alert Setting Descriptions
Setting Description
Status Determines if an alert is sent out for a specific printer event.
Delay Repeat Sets how often the alert is sent out for a specific printer
event. Range is 1 to 65535.
Delay Unit Selects the unit of measure that determines how often the
alert is sent out.
Message Sets the message that is sent out with each alert for a specific
printer event.
Error Alert Default Settings
Error Alert Status
Delay
Repeat
Delay Unit Message
Out of Media Enable 1 Occurrences Error - Out of media
Out of Ribbon Enable 1 Occurrences Error - Out of ribbon
Printer in
Pause Mode
Disable 1 Occurrences Printer in pause mode
Printer in
Menu Mode
Disable 1 Occurrences Printer in menu mode
Application
Break
Disable 1 Occurrences Error - Application
Break
RFID Not
Installed
Disable 1 Occurrences Error -RFID not
installed

Intermec PC43d Specifications

General

Print Technology	Direct Thermal
Print Resolution	203 dpi (8 dots/mm)
Max Print Width	4.1 inches
Max Print Speed	8 ips
Connectivity	USB, Serial, Ethernet
Media Handling	fanfold
Memory	128 MB Flash, 64 MB SDRAM
Media Type	Tags
Roll Maximum Outer Diameter	5 inches
Core Diameter	1 inch (25.4 mm) or 1.5 inches (38.1 mm)
Operating Temperature	+5°C to +40°C (+41°F to +104°F)
Storage Temperature	-20°C to +60°C (-4°F to +140°F)
Humidity	10 to 90% RH non-condensing
Power Requirements	100-240V AC, 50-60 Hz