Name: Intermec PC43d
Brand: Intermec
Rating: 5 (1 reviews)

To Next Page

To Previous Page

Chapter 2 — Set Up the Printer

42 PC23 and PC43 Desktop Printer User Manual

For a PC43t, thread the media through the media guides and past

the front of the printer. To adjust the width of the media guides,

slide the guides as needed to fit your media.

6 Close the printer lid until it snaps shut.

7 Turn the printer on and configure the feed adjust settings.

About Cut-Off Printing

In cut-off printing, each label is automatically cut from the media roll

immediately after the label is printed. You can print on non-adhesive,

continuous label stock. You can also use self-adhesive labels with a

liner, but you must cut only the liner.

The cutter module includes the Label Taken Sensor. You can also

install the optional cutter tray accessory, which holds up to 20 labels

or tickets.

After you load media, you need to configure the cutter and the feed

adjust settings. You may need to adjust the recommended values

slightly depending on your media type, supply method, and roll sizes,

or because of individual differences between printers.

Caution: You must not use the cutter to cut through any kind of

adhesive, or other soft material, that may stick to the cutting parts

and render the cutter inoperable or even damage the electric

motor.

Other manuals for Intermec PC43d

Questions and Answers:

Need help?

Do you have a question about the Intermec PC43d and is the answer not in the manual?

General