Intermec PC43d User Manual

Chapter 2 — Set Up the Printer
PC23 and PC43 Desktop Printer User Manual 59
8 Close the printer lid until it snaps shut.
9 If you have already configured the printer for thermal transfer
printing, continue with the next step. Otherwise, from the printer
Main Menu, select Settings > Printing > Media > Print Method >
Ribbon (TTR).
For an icon printer, you must use the printer web page or Intermec
PrintSet 5 to configure thermal transfer printing.
10 Save your changes.
Connect the Printer to Power
1 Connect the power adapter to the power port on the rear of the
printer.
2 Connect the power adapter to AC power. When the adapter is
connected to AC power, the green LED in the adapter connector
turns on and stays on.
Caution: Use only the AC power adapter supplied with the printer.
The use of a power adapter not approved by Intermec voids the
product warranty and may damage the printer.

Intermec PC43d Specifications

General

Print Technology	Direct Thermal
Print Resolution	203 dpi (8 dots/mm)
Max Print Width	4.1 inches
Max Print Speed	8 ips
Connectivity	USB, Serial, Ethernet
Media Handling	fanfold
Memory	128 MB Flash, 64 MB SDRAM
Media Type	Tags
Roll Maximum Outer Diameter	5 inches
Core Diameter	1 inch (25.4 mm) or 1.5 inches (38.1 mm)
Operating Temperature	+5°C to +40°C (+41°F to +104°F)
Storage Temperature	-20°C to +60°C (-4°F to +140°F)
Humidity	10 to 90% RH non-condensing
Power Requirements	100-240V AC, 50-60 Hz