Intermec PC43d User Manual

Appendix B — Default Settings
PC23 and PC43 Desktop Printer User Manual 145
• Faulty Dot (Sent when a faulty dot is detected in the printhead,
which can lead to lower print quality)
Ethernet Settings
This section describes the Ethernet IPv4 and IPv6 settings. To view
these settings:
• From the printer Main Menu, select Settings > Communications
> Ethernet.
• From the printer web page, click the Configure tab,
Communications > Ethernet.
Ethernet Settings
Setting Description Default
(IPv4) IP
Assignment
Method
Specifies how the printer obtains an IP
address.
DHCP
(IPv4) IP Address Specifies the unique network-level
address that is assigned to each device
in a TCP/IP network (IPv4).
0.0.0.0
Subnet Mask Specifies a number that defines the
range of IP addresses that can be used
in a TCP/IP network.
0.0.0.0
Default Router Specifies the IP address of a router that
is used when a device sends a packet to
another subnet or to an unknown
destination.
0.0.0.0
DHCP Response Specifies if the printer receives DHCP
responses by broadcast or unicast.
Broadcast
(IPv6) IP
Assignment
Method
Specifies how the printer obtains an IP
address (for IPv6 networks).
Automatic
(IPv6) IP Address Specifies the unique network-level
address that is assigned to each device
in a TCP/IP network (IPv6).
Automatic

Intermec PC43d Specifications

General

Print Technology	Direct Thermal
Print Resolution	203 dpi (8 dots/mm)
Max Print Width	4.1 inches
Max Print Speed	8 ips
Connectivity	USB, Serial, Ethernet
Media Handling	fanfold
Memory	128 MB Flash, 64 MB SDRAM
Media Type	Tags
Roll Maximum Outer Diameter	5 inches
Core Diameter	1 inch (25.4 mm) or 1.5 inches (38.1 mm)
Operating Temperature	+5°C to +40°C (+41°F to +104°F)
Storage Temperature	-20°C to +60°C (-4°F to +140°F)
Humidity	10 to 90% RH non-condensing
Power Requirements	100-240V AC, 50-60 Hz