Inventec N800G3 - Error Beep Codes; Recovery Code Checkpoints

04/01/2015 Inventec Corp. Confidential 79
4.2.7. Recovery Code Checkpoints
Checkpoint
Description
0xF0
Recovery condition triggered by firmware (Auto recovery)
0xF1
Recovery condition triggered by user (Forced recovery)
0xF2
Recovery process started
0xF3
Recovery firmware image is found
0xF4
Recovery firmware image is loaded
Recovery errors
0xF8
Recovery PPI is not available
0xF9
Recovery capsule is not found
0xFA
Invalid recovery capsule
0xFB ~ 0xFF
Reserved for future AMI error codes
4.2.8. Error Beep Codes
Number of Beeps
Description
1
Memory not Installed (PEI)
Memory was installed twice (PEI)
Invalid password (DXE)
3
DXEIPL was not found
DXE Core Firmware Volume was not found
4
Recovery failed (PEI)
Architectural Protocols are not available (PEI)
5
No Console Output Devices are found (DXE)
No Console Input Devices are found (DXE)
6
Flash update is failed (PEI)
7
Reset protocol is not available
8
Platform PCI resource requirements cannot be met