Need help?Do you have a question about the IpCAS ipEther232 and is the answer not in the manual?
Essential safety precautions for electrical equipment and device handling.
Explains using the device as a virtual COM port via TCP/IP, LAN, or WAN.
Details Telnet and Gateway modes for controlling serial devices over Ethernet.
Describes using the device as an Ethernet modem for serial device control.
Explains using the device for PPP gateway functionality to connect serial devices to the internet.
Details using the device as an SNTP timeserver for time synchronization.
Describes the device's function as a data logger for input signals.
Step-by-step guide for installing the device and its software.
Introduces the configuration tool for recognizing and managing devices.
Details how to configure the basic ipEther232 settings via the tool.
How to check if COM ports are free and available.
Configuration parameters for Transparent UDP Mode.
Technical details on send/receive operations and timeouts.
Setting the IP address for ipEther232.Telnet.
How to perform a connection test using ping and telnet.
Using the telnet command port for data transmission.
Details parameters, default values, and their meanings for ipEther232.Telnet.
Setting the "remoteip" parameter to close the telnet program.
Technical overview of ipEther232.Telnet including interface and protocols.
Setting up ipEther232.Modem using AT commands and network configurations.
Defining modem behavior options like call acceptance and echo.
Explains TC57 settings for fast frame transmission.
Connecting the device and configuring serial parameters using AT commands.
Setting up password protection for serial device access.
Instructions for installing the modem driver for ipEther232.Modem.
Quick reference for frequently used AT commands and registers.
Setting TCP/IP and PPP parameters for the device.
Steps to configure a PPP direct connection without modems.
How to view communication messages and analyze errors.
Setting TCP/IP parameters for the ipNTP device.
Steps to install and configure SNTP clients for time synchronization.
Setting TCP/IP parameters for the ipEther232.IO device.
General and IO commands with parameters for ipEther232.IO.
Details about sample applications and the IOBox.Reader.cs class.
Frequently Asked Questions about ipEther232 configurations and usage.
To Next Page
General