12 Uni-3 Technical Manual
14. Configure the scale as needed:
• Label Cassette (see Section 3.10 on page 46)
• Passwords (see Section 3.4 on page 36)
• Save temporary changes as permanent changes (see Section 3.7 on page 40)
• Barcode format–weight and fix price (see Section 3.13 on page 49)
• Show item description–L1 models only (see Section 3.14 on page 52)
• Error conditions (see Section 3.15 on page 54)
• Minimum print weight (see Section 3.20 on page 57)
• Maximum tare (see Section 3.20 on page 57)
15. If necessary, download or program the PLU file, messages, keyboards, etc., from SLP-5.
16. Test scale operation.
2.1.3 At the Customer’s Location–Wireless
1. Confirm all access points have been positioned and configured.
2. Position all scales.
3. If necessary, program the wireless settings, see Section 3.2 on page 33.
2.1.4 At the Customer’s Location–Wired
1. Confirm all Ethernet cables have been run.
2. Position all scales and connect them to the Ethernet cables (disconnect cable to internal bridge).
2.1.5 At the Customer’s Location–Wrap Up
1. Connect laptop to the network–confirm scale communications.
2. Test scale communication with the customer’s computer using the Ping command.
3. Install and configure SLP-5 on the costumer’s computer.
4. Test scale communications with SLP-5.
5. Back up all scales using SLP-5 Maintenance Utility on the customer’s computer.
6. Calibrate the scale, see Section 4.8 on page 68.
To Next Page
Loading...
Need help?
General
