Appendix 83
6.0 Appendix
6.1 Error Codes
For the single-line Uni-3L1 in some cases pressing the Up or Down arrow keys will toggle between the error
number and the description.
Error No. Error Description
105 Initialization Failed Perform memory initialization, see Section 4.6 on page 66
106 Battery is Fault Verify battery switch is on or replace battery
108 Clock Setting is Not Completed Yet Set up clock, see Section 4.2 on page 65
109 Printer 1 Initialization Was Not Done Yet Initialize printer one, see Section 4.7 on page 67
110 Machine Setting Is Not Completed Select machine type, see Section 4.11 on page 70
111 The Display Confirmation Is Not Completed Perform key check, see Section 4.4 on page 65
112 The Confirmation Of The Key Is Not Completed Perform key check, see Section 4.4 on page 65
114 The Data Composition Is Different Initialize the memory, see Section 4.6 on page 66
116 The Country Has Not Been Selected Select country, see Section 3.20 on page 57
202 PLU Master Is Not Programmed Check PLU number, program if necessary,
see Section 5.1 on page 72
203 POP Master Is Not Programmed Check POP number, program if necessary,
see Section 5.13 on page 81
212-216 Free Master Isn’t Registered Check Free Message, register if necessary,
see Section 5.16 on page 82
219 Store Master Is Not Programmed Check store number, program if necessary,
see Section 5.6 on page 78
221 Tare Limit Over (g) Re-program tare weight
222 Tare Weight is 0 g Set tare weight
223 Label Setting Master Is Not Programmed Check label number, program if necessary
266-000 File Input Error There is a file that failed during input, check USB
266-001 File Input Error Failed in reconstruction of SRAM data
267-000 File Output Error There is a file that failed during output, check USB
267-001 File Output Error Failed in SRAM data backup
268-000 File Delete Error There is a master file that failed in deleting
268-001 File Delete Error Failed in SRAM delete
268-002 File Delete Error Failed in Data delete
268-003 File Delete Error There is data that failed in deleting
271 Initialize Error There is master data that failed in initialization
275 Extra Message 1 not found The extra message 1 linked to the PLU does not exist. This error
message can be disabled at step B18-02-03.
276 Extra Message 2 not found The extra message 2 linked to the PLU does not exist. This error
message can be disabled at step B18-02-04.
277 Extra Message 3 not found The extra message 3 linked to the PLU does not exist. This error
message can be disabled at step B18-02-05.
281 Tare Limit Over (kg) Re-program tare weight
282 Tare Weight is 0 kg Set tare weight
283 Tare Limit Over (lb) Re-program tare weight
284 Tare Weight is 0 lb Set tare weight
312-000 Label Is Remaining Remove label or check peel sensor levels,
see Section 4.7 on page 67
313 Printer Thermal Head Is Up Put thermal head down
316 Markdown Price Is More Than Original Price Check price, markdown should be less than original price
321 Price Is Not Programmed Enter price, program if necessary
Table 6-1. Error Codes
To Next Page
Loading...
Need help?
General
