84 Uni-3 Operation Manual
347-000 Thermal Head Is Worn Out No effect on printing
347-001 Thermal Head Is Worn Out Effects printing on one side of the format. Change thermal head
347-002 Thermal Head Is Worn Out Not printing barcode correctly. Change thermal head
351 Label Is Remaining Remove label or check peel sensor levels,
see Section 4.7 on page 67
396 No USB Memory Check USB memory
703 Printer 1 Has Problem Printer queue is full. Turn off the scale. Wait 10 seconds
710-000 No Label For Printer 1 Change label roll
710-001 No Label For Printer 1 Thermal head is in the up position. Printing cannot resume until
the thermal head is locked down
710-002 No Label For Printer 1 Front cover is open. Close the front cover
711-000 Label Size Error For Printer 1 Remove label and press feed key
711-001 Label Size Error For Printer 1 Remove label and press feed key
711-002 Label Size Error For Printer 1 Remove label and open front cover
713 Too Many Characters On Format For Printer 1,
Failed In [*]
Check field and data
714-000 Remaining Label On Printer One Remove label
714-001 Remaining Label On Printer One Remove label
714-002 Remaining Label On Printer One Remove label
715-000 Thermal Head Is Worn Out For Printer 1 Change thermal head
715-001 Thermal Head Is Worn Out For Printer 1 Thermal head is worn, but there is no effect on printing
715-002 Thermal Head Is Worn Out For Printer 1 Change thermal head
1010 No Label for Printer 1 The label gap sensor did not detect the labels. Open the printer
door and confirm the labels are threaded correctly and are in the
label gap sensor.
1011 Label size error The length of the label does not match the label format. Confirm
the label are the correct length. Confirm the label are threaded
correctly and are in the label gap sensor. Check the length
(height) of the label format.
1601 Span Adjustment For Scale Is Not Completed Reset span, see Section 4.8 on page 68
14038-0001 SSID Length is invalid Check the SSID length
14038-0002 WEP 64 key length is invalid Check the WEP 64 key length. Hex: 10 characters, ASCII: 5
characters
14038-0003 WEP 128 key length is invalid Check the WEP 128 key length. Hex: 26 characters, ASCII: 13
characters
14038-0004 PSK length is invalid Check the PSK length. Hex: 64 characters, ASCII: 8-13
characters
14038-0005 WEP index number is invalid Check the WEP index number. Number should be between 1-4.
14038-0006 Key type is invalid Please check the key type or key data. Hex: 0-9, A-F
14038-0007 Communication error has occurred Check the connection with the WiPort bridge
14038-0008 An error has occurred Check the WiFi settings and repeat
14038-0009 WiFi settings have changed Press Enter to save the settings or Clear to exit.
14038-0010 Wait 30 seconds to enable WiFi settings Wait 30 second after pressing Enter.
Error No. Error Description
Table 6-1. Error Codes (Continued)
To Next Page
Loading...
Need help?
General
