ITEM C 3-Series User Manual

Start-up
Page 115
10.4 Connecting the item Servo Positioning Controller C 3-Series to the
power supply
 Ensure that the power supply is switched off.
 Plug the PHOENIX connector into the [X9] socket of the servo positioning controller.
 Connect the PE line of the mains power supply to the PE earthing (grounding) socket.
 Connect the 24 V connections to a suitable power supply unit.
 Establish the mains power supply connections.
 Check all of the connections.
10.5 Connecting the PC (serial interface)
 Plug the D-Sub connector of the serial interface cable into the socket for the serial interface of the PC and tighten the
locking screws.
 Plug the D-Sub connector of the serial interface cable into the socket [X5] RS232/COM of the item Servo Positioning
Controller C 3-Series and tighten the locking screws.
 Check all of the connections.
10.6 Connecting the PC (USB interface, alternative)
 Plug the plug A of the USB interface cable into the socket for the USB interface of the PC.
 Plug the plug A of the USB interface cable into the [X19] USB socket of the item Servo Positioning Controller C 3-Series.
 Check all of the connections.
10.7 Operability check
1. Ensure that the controller enable switch is turned off.
2. Switch on the power supply of all of the devices. The READY LED on the front panel of the servo positioning
controller should now light green.
If the READY LED does not light green but red, there is a malfunction. If the seven-segment display indicates a number
sequence, this is an error message. The underlying cause of the error must be eliminated. In this case, please continue with
chapter 11.2 Error messages (page 119) . If the device displays nothing, follow these steps:
3. Switch the power supply off.
4. Wait 5 minutes so that the DC bus circuit can discharge.
5. Check all of the connecting cables.
6. Check whether the 24 V power supply operates correctly.
7. Switch the power supply back on.

ITEM C 3-Series Specifications

General

Brand	ITEM
Model	C 3-Series
Category	Controller
Language	English