4-41
3. Move the cursor to the waypoint whose waypoint information you wish to display, and press
.
Refer to "4.8.1 Moving the Cursor within a List" for details regarding cursor movement.
WPT Info WPT Info (Details)
The following items can be set.
(1) WIDTH PORT: The port route width can be set.
(2) WIDTH STBD: The starboard route width can be set.
(3) ARRIVAL RAD: The arrival circle radius can be set.
(4) SPEED: The planned speed of the LEG can be set.
(5) SAIL GC/RL: The LEG distance calculation method can be set.
GC: Distance is calculated using the great circle method.
Even if GC is set, RL is shown on plot screen.
RL: Distance is calculated using the rhumb line method.
(6) STATUS: You can set whether the waypoint will be used or not.
(For newly created routes and routes with one waypoint, waypoints can not be set
as unused or deleted)
USED: The waypoint is used.
SKIP: The waypoint remains on the route, but is skipped.
All waypoints cannot be skipped.
DELETE: Delete from the route. The waypoint will remain on the waypoint list.
The waypoint on the active route cannot be deleted.
(7) DETAILS: ROT, turn radius, and time zone settings can be performed.
(7-1) TURN RATE: The rate of turn when passing a waypoint can be set.
(7-2) TURN RADIUS: The turn radius when passing a waypoint can be set.
(7-3) TIME ZONE: The time difference with the waypoint can be set.
LEG Information Screen
Cursor
Position
Distance from ship position to
cursor specified waypoint
Required time from ship position to
cursor specified waypoint
Up / Down Scroll
Bearing from previous
waypoint
LEG distance
LEG distance
calculation methods:
R:
Rhumb line
G: Great circle
No display : Use
SKIP: Skip Waypoint
To Next Page
Loading...
