JRC JLR-7500 - Stopping the Alarm Buzzer; Changing the Display; Displaying Alarm Information

4-9
4.2.5 Stopping the Alarm Buzzer
The buzzer can be stopped by pressing the key.
The buzzer sounds when one of the following occurs.
· Position measurement is interrupted
· An error occurs
· Mutual Acknowledgement Function
When positioning is stopped and the buzzer sounds, the mutual acknowledgement
function can be used to stop the buzzer from another unit. To use this function, units
must be connected via contact input / output or ALR, ACK sentences.
4.2.6 Changing the Display
Each time the key is pressed, the screen display changes. (Refer to "3.1 Display
Screen")
4.2.7 Displaying Alarm Information
Each time the key is pressed, the screen display changes.
When alarm information is updated, the * symbol appears on the status bar.
· If no alarm has occurred, "NO ALARMS" is displayed.
A
larm Number
A
: Alarm Occurred
V: Alarm Recovered
ACK: Acknowledgement
A
larm Contents
A
larm
Information
Display Area
A
larm Information Refresh Mark
A
larm Occurrence
Date/Time
Memo
Memo