4-116
(5) Remote maintenance data output setting
3. Use
to select "REMOTE MAINTE", and press .
4. Press
to select "ON", and then press .
5. Press
"CONNECT".
6. Select the connection destination with
, and press .
"MULTICAST", "UNICAST", or "BROADCAST" can be set as connection destinations.
Normally, "MULTICAST" should be selected.
When "UNICAST" is selected, destination IP "2. To IP" and "3. Port No." can be set.
7. Press
"INTERVAL".
8. Press
to select the output period, and press .
4.20.7.8 Setting Tidal Current Meter Input
· You can perform tidal current meter input settings.
· Data need to be entered starting with DATA IN4.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
, and then to select "DATA IN/OUT4".
3. Select "EXT EQUIP" with , and press
.
4. The tidal current meter input screen will be displayed.
You can select the layer and data number you wish to display.
Procedure
To Next Page
Loading...
