4-48
The following is an overview of the display.
ALL OVERWRITE: Overwrites from selected copy destination.
Overwriting cannot be performed for active routes.
In this case, "ALL OVER WRITE" is not displayed.
TO EMPTY AREA: Copying is performed to a different empty area:
When there are no empty area in list, "TO EMPTY AREA" is not
displayed.
CANCEL: Copying is cancelled.
· The boundary of 100 cannot be crossed when selecting multiple numbers as the copy
source.
Ex) A selection such as "99 - 101" is invalid.
4.5.5 Deleting Routes
· Routes registered between 1 and 100 can be deleted.
· The waypoint on the route to be deleted can be deleted at the same time.
· In the case the waypoint is also deleted, the waypoint used on the different route is not deleted.
· Active routes cannot be deleted.
1. Press
, , and then to display the waypoint/route deletion screen.
2. Press
"ROUTE DEL".
The following is an overview of the route deletion submenu.
(1) ALL: Delete all routes between 1 and 100.
(2) FROM TO: Enter the start and end points of the range to be deleted with the numeric
keypad.
(3) ROUTE LIST: Specify the range to be deleted on the waypoint list.
(4) ROUTE No.: Specify the route number to be deleted with the numeric keypad.
3. Press to select the route to be deleted, and then press
.
(1) When "FROM TO" is Selected
Enter the start point and end point with the numeric keypad, and press
.
(2) When "ROUTE LIST" is Selected
The route list will be displayed. Move the cursor to select the start and end points, and press
to select the range.
Please refer to "4.8.3 Selecting a Range within a List" for more details.
Memo
Procedure
To Next Page
Loading...
