JRC JLR-7500 - Setting Temperature Units; Setting Magnetic Correction

4-87
To keep the default value, or restore the unit to the default value, select "DEFAULT".
4.15.7 Setting Temperature Units
· You can set the temperature unit to ºC or ºF.
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "TEMPERATURE".
2. Select the units with , and press
.
4.15.8 Setting Magnetic Correction
· You can set the method of magnetic correction to be automatic or manual, or turn magnetic
correction off.
· If you select automatic, correction is automatically calculated for the correction value from the
GPS position.
· If you select manual, correction is performed using a manually entered value.
· If you turn magnetic correction off, no correction is performed.
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "MAG CORR".
2. Select the correction method with , and press
.
When Manual is selected
3. Select E/W using , enter the correction value with the numeric keypad, and press
.
Enter calculated
value and press
Procedure
Procedure