6-4
6.1.4 Installation of the Sensor to pass a cable through a pole
It is possible to pass a cable through a pole, when DGPS sensor attached to poles with cut male
screws. (1inch-14 UNS-2A). In this case, Cable guard rubber (attached article) used.
(1) The cable is installed as following figure.
Do not bend the cable acutely. Doing so may result in damage to the cable.
(2) Cable guard rubber is set in DGPS sensor.
Cable guard rubber
(attached
article)
Push all the way in
Do not bend it acutely
Cable installation figure
To Next Page
Loading...
