4-85
4.15 System Settings
· Select "5. SYSTEM" on the main menu to display the system settings screen.
The following is an overview of each submenu.
(1) TIME DIFF: To display the time at the current location, enter the difference between the
local time and UTC.
(2) DATE DISP: Select " 'YY-MM-DD", "DD MM, 'YY", or "MM DD, 'YY".
(3) TIME DISP: You can select 24 hour or 12 hour display.
(4) DATUM: You can select a geodetic system from the list in "Appendix 1 Geodetic
Systems".
(5) UNIT - DIST/SPEED: You can choose units of "NM, kn", "km, km/h", or "mi, mi/h".
(6) UNIT - HEIGHT/DEPTH: You can select m, ft, or fm.
(7) UNIT - TEMPERATURE: You can select
℃
or
℉
.
(8) MAG CORR: You can select automatic or manual magnetic correction, or turn magnetic
correction off.
(9) SPEED Meter: You can set the maximum value of the analogue speed meter on the
CDI screen.
4.15.1 Setting the Time Difference
· You can set the time difference between your current location and UTC.
An YY denotes a year, an MM denotes a month, and a DD denotes a day.
· For Japan, the time difference is +9 hours, so you would input +09:00.
· When a time difference is set, the local time will be displayed (shown with an "L").
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "TIME DIFF".
2. Select + or - with , enter the time with the numeric keypad, and press
.
4.15.2 Setting the Date Display
· You can set the date display format to " 'YY-MM-DD", "DD MM, 'YY", or "MM DD, 'YY".
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to select "DATE DISP".
2. Select the display format with , and press
.
Procedure
Procedure
To Next Page
Loading...
