4-29
4.4 Registering Waypoints
· Waypoints must be registered to the waypoint list to start navigation.
· Up to 10000 waypoints can be registered in this unit.
· The waypoint list is divided into 3 regions, managed via numbering from 1 - 11024.
1 - 10000: Waypoints registered in this unit.
10001 - 10512: Waypoints on shared active routes sent by ECDIS are registered.
10513 - 11024: Waypoints used in temporary routes are registered.
· Numbers 1 - 10512 are saved, and remain even if the power is turned off. 10513 - 11024 are
not saved, and will disappear if the power is turned off.
· Waypoints can be set between 89 degrees north and 89 degrees south.
4.4.1 Displaying the Waypoint List
Registered waypoints (waypoint number 1 - 10000) can be displayed.
Waypoint number 00001 is registered as "HOME PORT".
1. Press
, , and then , and display the waypoint list.
· The position registered as HOME in the waypoint list can be easily set as the waypoint
using the GOTO function.
It is convenient to register a frequently used waypoint (such as the home port) as
HOME.
Please refer to "4.6.2 Starting Navigation with the GOTO Key" for details regarding the
GOTO function.
· The waypoint on the route entered from an external device is displayed NEW at the
extreme right of the waypoint list and then registered. The NEW is displayed when a
waypoint on the next route has been entered or until the power is shut off.
Memo
Waypoint number of
cursor position
Waypoint entry number/total
number of waypoints
Waypoint No.
Symbol
Comment
Waypoint position
Up/Down
Scroll
Procedure
HOME PORT
"NEW"
Waypoint input
from external
source
To Next Page
Loading...
