4-103
6. The diagnosis results will be displayed.
After self-diagnosis has been performed for the screen, the entire screen is highlighted
repeatedly such as black to white, white to black. Check if some dots are omitted.
If you wish to stop the operation, press
.
If the results were not good, contact JRC or its affiliate.
4.20.4.3 Displaying and Outputting Error Logs
· Up to 100 recent errors can be displayed. They can also be output externally.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
"CHECK".
3. Press to select "ERROR LOG", and then press
.
The error log will be displayed.
3. If you want to output the log, press
and set output settings.
4. Set the output port and bit rate, and press
"SEND" to output the log in text format.
4.20.4.4 Outputting Settings
· Current setting values can be output. This function is for use by service engineer.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
"CHECK".
3. Press to select "CONFG OUT", and then press
.
4. Set the output port and bit rate, and press
"SEND" to output the log in binary format.
Procedure
Procedure
Attention
To Next Page
Loading...
