4-100
4.20.1 Setting the Display Type
· You can set whether the display is the main display connected to the GPS sensor, or a
sub-display.
· Set the display connected to the GPS sensor as "MAIN".
· Set the display used as a sub-display as "SUB".
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
"DISPLAY TYPE".
3. Press to select "MAIN" or "SUB", and press
.
If the unit is set to be the sub-display, " " will appear at the top right of the title bar.
·
Settings cannot be performed for the GPS sensor from the sub-display.
4.20.2 Setting the GPS Sensor Number
· A number can be assigned to each GPS when there is more than one GPS sensor.
· This number is used for IP address management of each display, and for GPS identification
when outputting data, so always perform GPS number configuration.
· When only 1 GPS is used, set the number to No1.
· Set a number for each display type, main and sub. Sub-displays are not connected to GPS
sensors, but must be set.
· Always set numbers in order starting from No1.
1. Refer to "4.20 Equipment Configuration" and display the equipment configuration menu.
2. Press
"SENSOR No.".
3. Enter the number with the numeric keypad, and press
.
The number will appear at the top right of the title bar.
Memo
Procedure
Procedure
To Next Page
Loading...
