JRC JLR-7500 - Centering the Cursor Position; Changing Cursor Size; Moving the Screen

4-11
4.3.1.3 Centering the Cursor Position
· The position of the cursor can be displayed at the center of the screen.
1. Display the cursor.
2. Move the cursor to the point on the screen which you want to be centered.
3. Press
.
The position the cursor was at will be moved to the center of the screen.
4.3.1.4 Changing Cursor Size
· The cursor size can be set to one of 3 sizes.
1. Press
, then , then to display the "PLOT SET2" Screen.
2. Press "CURSOR".
3. Use to select the size, and then press
.
4.3.2 Moving the Screen
· The screen can be moved up, down, left, right, and diagonally
1. If the cursor is displayed, press
to hide the cursor.
2. Press to move the screen up, down, left, or right.
Press , , or simultaneously to move the screen
diagonally. Holding the buttons down will cause the screen to accelerate while continuing its
movement.
Procedure
Procedure
Procedure