JRC JLR-7500 - External Interface

9-2
9.1.3 External Interface
(1)Serial Transmission
Channel Specification Notes
RS-422 Output NMEA,IEC,JRC DATA
IN/OUT1
RS-232C Input/Output - for PC or Printer
DATA OUT2 RS-422 Output NMEA,IEC,JRC
DATA OUT3 RS-422 Output NMEA,IEC,JRC
Input NMEA External Equipment DATA
IN/OUT4
RS-422
Output NMEA,IEC,JRC
(1-1)NMEA
・Specification ：NMEA0183
・Version ：Ver1.5,2.1,2.3
・Bit Rate ：4800,9600,19200,38400bps
・Data Bit ：8bit
・Parity Bit ：None
・Start Bit ：1bit
・Stop Bit ：1bit
・Output Sentence ：GGA,RMC,GLL,VTG,GSA,GSV,DTM,GBS,GRS,GST,ZDA,GNS,
MSS**,ALR,VDR*,VHW*,APB,BOD,BWC,BWR,RMB,XTE,ZTG,
AAM,ALR,RTE,WPL,ACK,
HDT*,THS*,DBT*,DPT*,MTW*,CUR*,VBW*
・Output Interval ：1s,2s,3s,4s,5s,6s,7s,8s,9s,OFF
・Input Sentence ：HDT,THS,DBT,DPT,MTW,CUR,VBW,VHW,ACK,WPL,RTE,ALR
**Function only available on JLR-7800
*External sensor must be connected
1）Some combinations of output sentence, bit rates, and output intervals may not be possible.
(1-2)IEC
・Specification ：IEC61162
(1-3)JRC
・Specification ：JRC
・Bit Rate ：1200bps
・Data Bit ：8bit
・Parity Bit ：None
・Start Bit ：1bit
・Stop Bit ：2bit
(2)Contact Signal
Channel I/O Notes
CONTACT
OUT1
Output Alarm,200p/NM,400p/NM,ACK
CONTACT
OUT2
Output Alarm,200p/NM,400p/NM,ACK
CONTACT 3 Input ACK
(3)LAN
・Specification ：JRC
・Bit Rate ：10/100Mbps
・Common Route ：JRC
・Data output ：NMEA,IEC