4-67
4.8.3 Selecting a Range within a List
· The following methods can be used to select a range in a list:
(1) The cursor can be moved via the up and down keys to select the start and end points
(2) The cursor can be moved by entering a number with the numeric keypad to select the
start and end points
· The two methods can be combined, such as selecting the start point with the up and down
keys, and the end point with the numeric keypad.
· This function is used when selecting a range of waypoint copy sources, route copy sources,
waypoints to be deleted, routes to be deleted, and events/marks to be deleted.
4.8.3.1 Moving the Cursor with the Directional Keys and Selecting a Range
The operation examples show selection of waypoints 2 to 5 in the waypoint list, but the
instructions provided apply to operation within all lists.
1. Display the list.
2. Press to move the cursor to "2", and press
to set the start point.
3. Press to move the cursor to "5", selecting the range from 2 to 5.
Press to move the cursor to the next page.
4. Press
to set the range.
Waypoint List
Move to destination number "2"
Start point "2" is set
Move to waypoint number "5"
and press to select
range.
Start point number
End point number
Total number
selected
Selection range
Number of cursor position
Procedure
To Next Page
Loading...
