4-32
4.4.2.3 Registering the Cursor Position
Any cursor position on the plot screen can be registered to the waypoint list.
1. Please refer to "4.4.2 Registering Waypoints" and display the waypoint registration screen.
2. Press
"POSITION".
3. Press , move the cursor to "CURSOR", and press .
4. The plot screen will be displayed.
Press to move the cursor, and press
at the position you wish to
register.
When the cursor is moved, the cursor position is displayed at the top right of the screen.
5. The cursor position is shown in "5. WPT LAT", "6. WPT LON".
6. Press
"ENTRY".
4.4.2.4 Registering a Bearing and Distance from a Specified Position
A position can be specified as a start point, and then another position defined by its bearing and
distance from said start point can be registered to the waypoint list.
Any of the following 6 can be used as a start point.
(1) Specified Longitude Latitude: Select "LAT/LON".
(2) Own Ship Position: Select "OWN SHIP".
(3) Cursor Position on Plot Screen: Select "CURSOR".
(4) Position Registered in Waypoint List: Select "WPT LIST".
(5) Position Registered in Event/Mark List: Select "EVENT LIST".
(6) When Continually Setting Waypoints, the Last Registered Position: Select "PRE WPT"
1. Please refer to "4.4.2 Registering Waypoints" and display the waypoint registration screen.
2. Press
"POSITION".
3. Press , move the cursor to "BRG/DIST", and press
.
4. The start position setting screen will be displayed.
Press
"START POINT", press to select the start point, and press .
(1) When "LAT/LON" is Selected
Press
"START LAT", enter the latitude with the numeric keypad, and press .
N/S can be selected via .
Press
"START LON", enter the longitude with the numeric keypad, and press .
E/W can be selected via .
When "START LAT" is entered, the cursor moves automatically to the latitude numerical
entry position. If "START LON" entry is unnecessary, press
.
Procedure
Procedure
To Next Page
Loading...
