4-93
4.16.8 Setting Beacon/SBAS
Beacon and SBAS settings can be performed.
The sensor must support SBAS to perform SBAS settings.
· The submenus on the beacon/SBAS settings screen are as follow.
(1) STATION SELECT: Set the beacon station selection method.
AUTO: The best beacon station is selected automatically from the GPS
position.
MANUAL: You can set the frequency and bit rate manually.
(2) FREQUENCY: Set the frequency when station selection is set to manual.
(3) BIT RATE: Set the bit rate when station selection is set to manual.
(4) BEACON INFORMATION: Set to "ON" to display received beacon information.
(5) SBAS SEARCH: The SBAS satellite can be set.
AUTO: The SBAS satellite is automatically set.
MANUAL: The SBAS satellite number is set manually.
(6) TYPE 0 INFORMATION: Set whether test broadcast data is used.
ON: Used.
OFF: Not used. (default)
(7) RANGING: You can set whether SBAS satellite information are used like
GPS satellites in positioning.
ON: Used.
OFF: Not used. (default)
· Please refer to "4.20 Equipment Configuration" and switch the unit to equipment configuration
mode.
1. Press
, , and then to display the Beacon/SBAS setting screen.
(1) Setting Beacon station
2. Press
"STATION SELECT".
3. Press to select the method, and press
.
If set to Manual, "2. FREQUENCY" and "3. BIT RATE" can be selected.
Press
"FREQUENCY".
Enter the frequency with the numeric keypad, and press .
Press
"BIT RATE".
Press to select the bit rate, and press
.
(2) Setting Beacon Information
Refer to "4.13 Beacon Information".
Procedure
To Next Page
Loading...
