JRC JLR-7500 - Startup (Error-1); Startup (Error-2)

4-6
4.2.1.2 Startup (Error-1)
If any of the self-diagnosis results are "NG", the results are displayed.
The unit does not switch to the standard screen unless the
key is pressed.
If any errors (NG) are detected, please contact JRC or an affiliate.
4.2.1.3 Startup (Error-2)
Messages shown below may be displayed during sensor diagnostics.
The message appears when display unit and sensor configuration settings do not match, such as
when equipment has been replaced.
When this occurs, select one of the items, and press the
key to perform it.
[ 1. USE SENSOR CONFIG.]: Replaces display configuration with the sensor configuration.
[ 2. USE DISPLAY CONFIG.]: Replaces the sensor configuration with the display
configuration.
Consult with JRC or its affiliate if this is displayed frequently.
Attention
Attention