Juniper EX2300 Series - Page 185

1. Transion the switch into inial setup mode:
• EX2200 and EX2200-C switch—Press the mode buon located on the lower right corner of the
front panel for 10 seconds.
• EX3200, EX3300, EX4200, EX4300 switches except EX4300-48MP and EX4300-48MP-S
switches, EX4500, EX4550, EX6200, or EX8200 switch—Use the Menu and Enter buons
located to the right of the LCD panel (see Figure 88 on page 176 or Figure 89 on page 176):
Figure 88: LCD Panel in an EX3200, EX4200, EX4500, EX4550, or EX8200 Switch
Figure 89: LCD Panel in an EX4300 Switches Except EX4300-48MP and EX4300-48MP-S
Switches
1
— LCD panel 3— LCD panel Menu buon
2— LCD panel Enter buon 4— Chassis status LEDs
a. Press the Menu buon unl you see MAINTENANCE MENU. Then press the Enter buon.
b. Press Menu unl you see ENTER EZSetup. Then press Enter.
If EZSetup does not appear as an opon in the menu, select Factory Default to return the
switch to the factory default conguraon. EZSetup is displayed in the menu of standalone
switches only when a switch is set to the factory default conguraon.
c. Press Enter to conrm setup and connue with EZSetup.
2. Connect the Ethernet cable from the Ethernet port on the PC to the switch.
176