Juniper EX2300 Series - Page 44

1—
LEDs on the uplink ports
Figure 26: LEDs on the Uplink Ports in an EX2300 Switches Except the EX2300-C, EX2300-24MP, and
EX2300-48MP Switche Models
1—
LEDs on the uplink ports
Table 10 on page 35 describes the Link/Acvity LED on EX2300 switches except the EX2300-24MP
and EX2300-48MP models.
Table 10:
Link/Acvity LED on the RJ-45 Network Ports and Uplink Ports in EX2300 Switches Except
the EX2300-24MP and EX2300-48MP Models
LED Color State and Descripon
Link/Acvity Green
• Blinking—The port and the link are acve, and there is link
acvity; or the switch is transioning to the EZSetup mode.
• On steadily—The port and the link are acve, but there is no link
acvity; or the switch is reverng to the factory default
conguraon.
• O—The port is not acve.
Figure 27 on page 36 shows the LEDs on EX2300 switches except the EX2300-24MP and
EX2300-48MP models that indicate the status of one of the four port parameters—speed, duplex mode,
administrave status, and Power over Ethernet (PoE) status. Use the Factory Reset/Mode buon on the
far right side of the front panel to toggle the Status LED to show the dierent port parameters for RJ-45
network ports. You can tell which port parameter is indicated by the Status LED by looking at which port
35