status mode LED (SPD, DX, EN, and PoE) is lit. The LED labeled PoE is not available on switch models
with RJ-45 network ports that do not provide PoE.
Figure 27: Port Mode LEDs on EX2300 Switches Except the EX2300-24MP and EX2300-48MP Models
1—
Port mode LEDs
Table 11 on page 36 describes the Status LED on the RJ-45 network ports in EX2300 switches except
the EX2300-24MP and EX2300-48MP switch models.
Table 11: Status LED on the RJ-45 Network Ports in EX2300 Switches Except the EX2300-24MP and
EX2300-48MP Models
Port Parameters State and Descripon
Speed (SPD) Indicates the speed. The speed indicators are:
• Unlit—10 Mbps
• Blinking—100 Mbps
• On steadily—1000 Mbps
Duplex mode (DX)
NOTE: On EX2300-24T switches,
only the ports labeled 0/0 through
0/15 support half-duplex. On
EX2300-48T switches, only the
ports labeled 0/0 through 0/15 and
0/24 through 0/39 support half-
duplex.
Indicates the duplex mode. The status indicators are:
• Green—Port is set to full-duplex mode.
• Unlit—Port is set to half-duplex mode.
36
To Next Page
Loading...
