CAUTION: The V+ terminals are shunted internally together, as are the
V- terminals. The same polarity terminal can be wired together from the
same source to provide an additional current path in a higher power
chassis. Do not connect the terminals to different sources.
Figure 30: Securing Ring Lugs to the Terminals on the QFX5110 DC Power
Supply
8. Replace the terminal block cover.
9. Close the input circuit breaker.
NOTE: The switch powers on as soon as power is provided to the power
supply. There is no power switch on the device.
10. Verify that the IN and OUT LEDs on the power supply are lit green and are on steadily.
Related
Documentation
• QFX5110 DC Power Supply on page 35
• QFX5110 DC Power Supply LEDs on page 38
91Copyright © 2017, Juniper Networks, Inc.
Chapter 10: Connecting the Switch to Power
To Next Page
Loading...
