Juniper QFX5110 - Figure 6: Management Panel Components on QFX5110

Figure 6: Management Panel Components on QFX5110
4—1— USB portStatus LEDs
5—2—
em1–SFP management Ethernet port (C1)
Cage (socket for either 1-GbE copper SFP
or fiber SFP)
em0–RJ-45 (1000BASE-T) management
Ethernet port (C0)
and an additional SFP management
Ethernet port (second C0)
3—
RJ-45 console port (CON)
The management panel consists of the following components:
•
Status LEDs, see “QFX5110 Chassis Status LEDs” on page 21.
•
Switch product number
•
Management ports C0 and C1, see “QFX5110 Management Port LEDs” on page 20.
•
C0–Use the RJ-45 connectors for 10/100/1000BASE-T or to cable a virtual
management Ethernet (VME) interface for spine members in a VCF. See Connecting
a QFX5110 to a Network for Out-of-Band Management.
NOTE: If both C0 ports are cabled, the copper C0 has priority over the
fiber C0.
•
C1–Use the SFP connector for 1000BASE-X.
•
USB port for image updates
•
Console port (RJ-45) to support RS-232 serial ports. The LEDs above the port indicate
status and link.
Related
Documentation
QFX5110 Field-Replaceable Units on page 15•
• QFX5110 Chassis Status LEDs on page 21
• USB Port Specifications for the QFX Series on page 69
• QFX5110 Cooling System and Airflow on page 25
• QFX5110 AC Power Supply on page 33
19Copyright © 2017, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions