Table 6: FRUs in a QFX5110
Required ActionFRU
None.Power supplies
None.Fan modules
None. We recommend that you disable the interface using the set interfaces
interface-name disable command before you remove the transceiver. See
Disconnecting a Fiber-Optic Cable from a QFX Series Device.
Optical transceivers
NOTE: If you have a Juniper Care service contract, you can register any
addition, change, or upgrade of hardware components at
https://www.juniper.net/customers/support/tools/updateinstallbase/. Failure
to do so can result in significant delays if you need replacement parts. This
note does not apply if you replace existing components with the same type
of component.
Related
Documentation
Installing a Fan Module in a QFX5110 on page 105•
• Removing a Fan Module from a QFX5110 on page 106
• Installing a Power Supply in a QFX5110 on page 109
• Removing a Power Supply from a QFX5110 on page 111
• Installing a Transceiver in a QFX Series Device on page 113
• Removing a Transceiver from a QFX Series Device
QFX5110 Access Port and Uplink Port LEDs
The Link/Activity LED configuration for QFX5110 uses bi-colored LEDs. The link LED
indicates link activity or a fault. See Table 7 on page 17.
Copyright © 2017, Juniper Networks, Inc.16
QFX5110 Switch Hardware Guide
To Next Page
Loading...
