Juniper QFX5110 - Connecting QFX5110 and QFX5100 Members in a QFX5110 Virtual Chassis

CHAPTER 9
Unpacking and Mounting the Switch
•
Installing and Connecting a QFX5110 on page 75
•
Unpacking a QFX5110 on page 76
•
Mounting a QFX5110 in a Rack on page 77
•
Virtual Chassis Fabric Installation Overview on page 80
Installing and Connecting a QFX5110
You can mount a QFX5110:
•
Flush with the front of a 19-in. four-post rack. Use the standard mounting brackets
provided with the switch for this configuration.
•
Recessed 2 in. (5 cm) from the front of a 19-in. four-post rack. Use the extension bracket
provided in the standard mounting kit for this configuration.
To install and connect a QFX5110:
1. Follow the instructions in “Unpacking a QFX5110” on page 76.
2. Determine how the switch is to be mounted.
Flush or recessed-mounted in a rack, see “Mounting a QFX5110 in a Rack” on page 77.
3. Follow the instructions in:
a. Connecting Earth Ground to a QFX5110 on page 84
b. “Connecting AC Power to a QFX5110” on page 85 or Connecting DC Power to a
QFX5110 on page 87
c. Registering Products—Mandatory for Validating SLAs
4. Follow the instructions in “Configuring a QFX5110” on page 99.
Related
Documentation
QFX5110 Rack Requirements on page 53•
75Copyright © 2017, Juniper Networks, Inc.