Juniper QFX5110 User Manual

•
Do not open or remove chassis covers or sheet-metal parts unless instructions are
provided in the hardware documentation for this device. Such an action could cause
severe electrical shock.
•
Do not push or force any objects through any opening in the chassis frame. Such an
action could result in electrical shock or fire.
•
Avoid spilling liquid onto the chassis or onto any device component. Such an action
could cause electrical shock or damage the device.
•
Avoid touching uninsulated electrical wires or terminals that have not been
disconnected from their power source. Such an action could cause electrical shock.
•
Always ensure that all modules, power supplies, and cover panels are fully inserted
and that the installation screws are fully tightened.
Related
Documentation
AC Power Electrical Safety Guidelines on page 184•
• General Electrical Safety Guidelines and Warnings on page 181
• Maintenance and Operational Safety Guidelines and Warnings on page 175
• Installation Instructions Warning on page 161
• Grounded Equipment Warning on page 168
Definitions of Safety Warning Levels
The documentation uses the following levels of safety warnings (there are two Warning
formats):
NOTE: You might find this information helpful in a particular situation, or you
might overlook this important information if it was not highlighted in a Note.
CAUTION: You need to observe the specified guidelines to prevent minor
injury or discomfort to you or severe damage to the device.
WARNING: This symbol alerts you to the risk of personal injury from a laser.
WARNING: This symbol means danger. You are in a situationthat could cause
bodily injury. Before you work on any equipment, be aware of the hazards
involved with electrical circuitry and be familiar with standard practices for
preventing accidents.
Waarschuwing Dit waarschuwingssymbool betekent gevaar. U verkeert in
een situatie die lichamelijk letsel kan veroorzaken. Voordat u aan enige
Copyright © 2017, Juniper Networks, Inc.154
QFX5110 Switch Hardware Guide

Juniper QFX5110 Specifications

General

Model	QFX5110
Power Supply	Dual, hot-swappable
Rack Units	1U
Operating Relative Humidity	5% to 90% non-condensing
Input Voltage	100-240 VAC
Operating System	Junos OS
Layer Support	Layer 2 and Layer 3
Virtual Chassis Support	Yes
Ports	48 x 10GbE SFP+
Jumbo Frames	9216 bytes
Operating Temperature	32°F to 104°F (0°C to 40°C)
Operating Altitude	Up to 3, 048 m
Management	CLI
AC Input Frequency	50/60 Hz
Storage Temperature	-40°C to 70°C
MTBF	Consult Juniper documentation for specific values.