Juniper QFX5110 - Replacing Transceivers and Fiber-Optic Cables; Installing a Transceiver in a QFX Series Device

CHAPTER 11
Connecting the Switch to the Network
•
Connecting a Device to a Network for Out-of-Band Management on page 93
•
Connecting a Device to a Management Consoleby Using an RJ-45 Connector on page94
•
Connecting QFX5110 and QFX5100 Members in a QFX5110 Virtual Chassis on page 95
•
Connecting a QFX5110 Device in a QFX5110 Virtual Chassis Fabric on page 96
Connecting a Device to a Network for Out-of-Band Management
You can monitor and manage these devices by using a dedicated management channel.
Each device has a management port to which you can connect an Ethernet cable with
an RJ-45connector. Use the managementport to connect the devicetothe management
device.
Ensure that you have an Ethernet cable that has an RJ-45 connector at either end.
Figure 31 on page 93 shows the RJ-45 connector of the Ethernet cable supplied with the
device.
Figure 31: RJ-45 Connector on an Ethernet Cable
To connect a device to a network for out-of-band management (see
Figure 32 on page 94):
1. Connect one end of the Ethernet cable to the management port (labeled MGMT or
ETHERNET) on the device.
2. Connect the other end of the Ethernet cable to the management device.
93Copyright © 2017, Juniper Networks, Inc.