Juniper QFX5110 - Connecting QFX5110 and QFX5100 Members in a QFX5110 Virtual Chassis; Figure 34: Connecting a Device to a Management Console through a Console; Figure 35: Connecting a Device Directly to a Management Console

To connect the device to a management console (see Figure 34 on page 95 and
Figure 35 on page 95):
1. Connect one end of the Ethernet cable to the console port (labeled CON, CONSOLE,
or CON1) on the device.
2. Connect the other end of the Ethernet cable to the console server (see
Figure 34 on page 95) or management console (see Figure 35 on page 95).
Figure 34: Connecting a Device to a Management Console Through a
Console Server
g020547
CON
To Console
port Console server
PC
Figure 35: Connecting a Device Directly to a Management Console
Related
Documentation
Connecting a Device to a Network for Out-of-Band Management on page 93•
Connecting QFX5110 and QFX5100 Members in a QFX5110 Virtual Chassis
QFX5110 Virtual Chassis are cabled in a ring topology. Each Virtual Chassis has a master,
a backup, and up to 8 additional switches participating as members of the Virtual Chassis.
Select models of QFX5100 are allowed as line cards in a QFX5110 Virtual Chassis. For
sample cabling diagrams, see Figure 36 on page 96 and Figure 37 on page 96
95Copyright © 2017, Juniper Networks, Inc.
Chapter 11: Connecting the Switch to the Network