Juniper QFX5110 - Site Planning, Preparation, and Specifications; QFX5110 Site Preparation Checklist

Table 11: Chassis Status LEDs on a QFX5110 Switch (continued)
DescriptionStateColorName
The beacon feature is not enabled on the
switch. This feature is enabled using the
request chassis beacon command.
OffUnlitID–Identification
The beacon feature is enabled on the
switch. This feature is enabled using the
request chassis beacon command.
BlinkingBlue
Related
Documentation
• QFX5110 Management Panel on page 18
• show chassis alarms
• request chassis beacon
23Copyright © 2017, Juniper Networks, Inc.
Chapter 2: Chassis Components and Descriptions