Juniper QFX5240 - Page 33

Table 7: Chassis Status LEDs on QFX5240 Switches (Connued)
Name Color State Descripon
SYS–System Unlit O The device is powered o or halted.
NOTE: The SYS LED glows green
during BIOS boong.
Green On steadily Junos OS Evolved is loaded on the
device.
ID–Idencaon Unlit O The beacon feature is not enabled
on the switch. Enable this feature by
using the request chassis beacon fpc
0 on operaonal mode command.
NOTE: The ID LED glows green
during BIOS boong.
Blue Blinking The beacon feature is enabled on
the switch. Disable this feature by
using the request chassis beacon fpc
0 off operaonal mode command.
TIP: To nd the status of the beacon, use the show chassis beacon operaonal mode command.
user@host> show chassis beacon
OFF
Management Port LEDs
The RJ-45 management port on a QFX5240 has two LEDs that indicate link status and link acvity. The
management port is labeled MGMT. See Figure 14 on page 27.
26