KaVo 3D eXam - Page 93

K990400 16 April 2008
Detail Screens
8-15
To view the result of a linear slice:
1. To view a linear slice, right click the
view and select Line.
A pointer cursor is displayed.
2. Drag to position the linear slice.
The resulting slice is displayed (lower right of the MPR Screen.)
3. To reposition the line, drag either end point of the line.
To view the result of a non-linear
(irregular) slice:
1. To view a non-linear slice, right click
view and select Irregular.
A pointer cursor is displayed.
2. Drag cursor to create slice as desired.
The resulting slice is displayed in the
view at the lower right of the MPR
Screen.